Search results for "la-3791"

Trace Preprocessor for MPC880 and MPC885, connection to TCON320, 80 MHz bus clock

Supports MCS12Z, MCS12X, MCS12, HC12. Includes software for Windows, Linux and macOS. Requires PowerDebug base module. Not supported are the very old 1st Gen. PowerDebug modules LA-7702 (without USB) and LA-7704 (with USB 1.1).

Supports Trace for ARM Cores Please add the base serial number of your existing AutoFocus II preprocessor, AutoFocus II MIPI preprocsssor, serial preprocessor or PowerTrace Serial to your order.

State-Timing Analyzer to record digital or analog signal via suitable probes. Records up to 102 (51) channels, 200 (400) MHz state, 250 (500) MHz timing, transient recording, 64 MFrames, 48-bit time-stamp, trigger, filter, trigger Delay, etc. This is an extension that attaches to an existing PowerDebug X50, PowerDebug PRO, or PowerDebug II. Available probes: LA-7945 Standard Probe (17 digital single-ended signals) LA-7944 Mictor Probe (34 digital single-ended signals) LA-7946 Samtec Probe (34 digital single-ended signals) LA-7947 Mictor Differential Probe (17 digital differential signals) LA-7954 Mictor Probe with differential clock (32 se + 1 diff signal) LA-7958 Samtec Probe with differential clock (32 se + 1 diff signal) LA-7961 USB2 Probe LA-7943 DigRF Probe Set LA-7949 Analog Probe

Supports off-chip trace port for Ceva-X if applied to an AUTOFOCUS II preprocessor please add the serial number of the preprocessor to your order AUTOFOCUS II Preprocessors with serial number C0806xxxxxx and lower have to be send to Lauterbach Germany for an hardware upgrade

supports (1.8V - 5.0V) MPC86xx requires a valid software guaranty or a valid software maintenance key not suitable for debug cables older than 02/2004 (blue ribbon cable) please add the serial number of the existing debug cable to your order

Supports Armv8-A/R or Armv9-A/R based Cortex-A and Cortex-R 32/64-bit cores IDC20A debug cable supports 5-pin standard JTAG, cJTAG and Serial Wire Debug Port, (0.4 V - 5 V) Multicore debugging included includes software for Windows, Linux and MacOSX requires Power Debug Module cJTAG and SWD require Power Debug Interface USB 2.0/USB 3.0, Power Debug Ethernet, PowerTrace, Power Debug II or PowerDebug PRO

Converter Mictor38/20 Pin JTAG (ARM and TI) to 60 Pin CTOOLS connector on target

Converter for SH-JTAG 14 pins to SH-JTAG 36 pins on Hirose connector

Trace Support for RH850 please add the base serial number of your debug cable to your order