Search results for "a20"

Replacement part 50 mm used for LA-4503 and LA-4513.

Converter KEL connector to debug cable

Converter to connect the CombiProbe to a connector specified by Texas Instruments (TI) which is used on a few targets with TI processors.

Converter from Mictor76 to Samtec20 for: LA-7630 (NEXUS Debugger/Trace for MPC5xxx AutoFocus) LA-7635 (NEXUS Debugger/Trace for MAC71xx AutoFocus)

Converter from IDC20A to 12 pin PMOD connectors with the JTAG pinout from SiFive. The adapter exists in two variants: with male and female PMOD connector. This adapter has the female PMOD connector. PMOD is an open standard defined by Digilent for peripherals used with FPGAs or microcontrollers. The PMOD pinout of this adapter does ONLY work with targets that use the pinout that was defined by SiFive. So it is not a general/official RISC-V pinout. In case of FPGA boards, the pinout may depend on the used FPGA image.

Converter from IDC20A to 12 pin PMOD connectors with the JTAG pinout from SiFive. The adapter exists in two variants: with male and female PMOD connector. This adapter has the male PMOD connector. PMOD is an open standard defined by Digilent for peripherals used with FPGAs or microcontrollers. The PMOD pinout of this adapter does ONLY work with targets that use the pinout that was defined by SiFive. So it is not a general/official RISC-V pinout. In case of FPGA boards, the pinout may depend on the used FPGA image.

Supports Armv7-A/R based Cortex-A and Cortex-R 32-bit cores GTM and IPU debugging included IDC20A debug cable supports 5-pin standard JTAG, cJTAG and Serial Wire Debug Port, (0.4V - 5V) Includes software for Windows, Linux and macOS cJTAG and SWD require PowerDebug Interface USB 2.0/USB 3.0, PowerDebug Ethernet, PowerTrace, PowerDebug II PowerDebug PRO, PowerDebug E40 or PowerDebug X50

supports StarCore please add the serial number of the existing debug cable to your order

supports Teak, Teaklite and Teaklite-II with JAM interface please add the serial number of the existing debug cable to your order

Supports 78K0R and RL78 cores (16-bit). Uses IDC20A debug cable, which supports 5-pin standard JTAG, cJTAG (IEEE 1149.7) and Serial Wire Debug (SWD), (0.4V - 5V) Includes software for Windows, Linux and macOS. Requires PowerDebug base module. Not supported are the very old 1st Gen. PowerDebug modules LA-7702 (without USB) and LA-7704 (with USB 1.1).